You are required to ascertain the suitability of Azbil TA Co., Ltd.'s product in case of your use of the same with your machinery, equipment, etc. (hereinafter referred to as "Equipment") on your own responsibility, taking the following matters into consideration:

Azbil TA Co., Ltd.'s products shall not be used in a nuclear energy controlled area (radiation controlled area).
Any Azbil TA Co., Ltd.'s products shall not be used for/with medical equipment.
The products are for industrial use. Do not allow general consumers to install or use any Azbil TA Co., Ltd.'s product. However, azbil products can be incorporated into products used by general consumers. If you intend to use a product for that purpose, please contact one of our sales representatives.
In addition, you are required to conduct a consultation with our sales representative and understand detail specifications, cautions for operation, and so forth by reference to catalogs, specifications, instruction manual, etc. in case that you intend to use azbil product for any purposes specified in (1) through (6) below.

Moreover, you are required to provide your Equipment with fool-proof design, fail-safe design, anti-flame propagation design, fault avoidance, fault tolerance, and other kinds of protection/safety circuit design on your own responsibility to ensure reliability and safety, whereby preventing problems caused by failure or nonconformity.

Use of Azbil TA Co., Ltd.'s products, including switches, which contain electronic components, over a prolonged period may degrade insulation or increase contact-resistance and may result in heat generation or any other similar problem causing such product or switch to develop safety hazards such as smoking, ignition, and electrification.
Although acceleration of the above situation varies depending on the conditions or environment of use of the products, you are required not to use any Azbil TA Co., Ltd.'s products for a period exceeding ten (10) years unless otherwise stated in specifications or instruction manuals.

Mechanical components, such as relays and switches, used for Azbil TA Co., Ltd.'s products will reach the end of their life due to wear by repetitious open/close operations.
In addition, electronic components such as electrolytic capacitors will reach the end of their life due to aged deterioration based on the conditions or environment in which such electronic components are used.
Although acceleration of the above situation varies depending on the conditions or environment of use, the number of open/close operations of relays, etc. as prescribed in specifications or instruction manuals, or depending on the design margin of your machine or equipment, you are required to renew any Azbil TA Co., Ltd.'s products every 5 to 10 years unless otherwise specified in specifications or instruction manuals.
System products, field instruments (sensors such as pressure/flow/level sensors, regulating valves, etc.) will reach the end of their life due to aged deterioration of parts.
For those parts that will reach the end of their life due to aged deterioration, recommended replacement cycles are prescribed. You are required to replace parts based on such recommended replacement cycles.

Prior to your use of Azbil TA Co., Ltd.'s products, you are required to understand and comply with specifications (e.g., conditions and environment of use), precautions, warnings/cautions/notices as set forth in the technical documents prepared for individual Azbil TA Co., Ltd.'s products, such as catalogs, specifications, and instruction manuals to ensure the quality, reliability, and safety of those products.

Please note that the descriptions contained in any documents provided by azbil are subject to change without notice for improvement or for any other reason. For inquires or information on specifications as you may need to check, please contact our branch offices or sales offices, or your local sales agents.

Please note that the production of any Azbil TA Co., Ltd.'s product may be discontinued without notice.
For repairable products, we will, in principle, undertake repairs for five (5) years after the discontinuance of those products. In some cases, however, we cannot undertake such repairs for reasons, such as the absence of repair parts.
For system products, field instruments, we may not be able to undertake parts replacement for similar reasons.

Prices of Azbil TA Co., Ltd.'s products do not include any charges for services such as engineer dispatch service. Accordingly, a separate fee will be charged in any of the following cases: